User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
44
Joining the Mounting Brackets
Mounting on a Horizontal Pole
Mounting on a Horizontal Pole
1. Join the two brackets as shown in Figure 30. Make sure that:
• The dynamic bracket (attached to the Access Point) encloses the static bracket
(attached to the mounting surface).
• The side of the Access Point with the antenna connector is at the bottom, especially
if you are planning to install an external antenna.
Figure 30. Join the two brackets
2. Align the mounting holes on the dynamic bracket with the mounting holes on the static
bracket.
3. Place a split lock washer, and then a flat washer onto a hex bolt. Then insert the hex
bolt into one of the mounting holes.
NOTE: Make sure the screw-washer assembly is in correct order. The split-lock washer
should be in the middle and the flat washer should touch the bracket.
4. Repeat Step 3 for each of the mounting holes. There are four mounting holes on the
bracket – two on each side.