User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
40
Verifying the Installation
Associate a Wireless Client with the Access Point
Figure 27. Fasten the bottom cover using three machine screws
You have completed connecting the Access Point to the administrative computer and a
power source.
7 Verifying the Installation
Ruckus Wireless strongly recommends that you verify that the Access Point is operating
correctly and that wireless clients are able to associate with it before you mount the unit.
Perform the following tasks to verify the installation.
Associate a Wireless Client with the Access Point
1. On the administrative computer, verify that the wireless interface is enabled. On
Windows XP, click All Programs > Connect To > Wireless Network Connection to
enable the wireless interface.
2. In the system tray, right-click the (Wireless Network Connection) icon, and then
click View Available Wireless Networks.
3. In the list of available wireless network, click the network with the same SSID as you
configured in “Configure Wireless # Settings”
on page 21. For example, if you set the
SSID to Ruckus Wireless AP, click the wireless network named Ruckus Wireless AP.