User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
39
Connecting to the Network
Step 2: Attach the Dynamic Bracket to the Access Point
Figure 26. Install the white P-clip clamp and the black rubber O-ring
CAUTION: If you are not connecting the DC cable to the DC terminal block, make sure
you cover the right cable groove with one of the supplied solid rubber stoppers.
10. Place the bottom cover of the Access Point onto the bottom section, and then fasten
it using the three machine screws that are supplied with the Access Point.
CAUTION: Before installing the bottom cover, verify that the perimeter rubber gasket on
the underside of the cover is clear of debris.
Rubber
O-ring
P-clip Cable
Clamp