User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
38
Connecting to the Network
Step 2: Attach the Dynamic Bracket to the Access Point
Figure 25. Connect the ground wire to the V- terminal and the +12v DC wire to the V+
terminal
d. Using a 3mm Phillips screw, tighten the wiring terminal screws.
e. Wrap the white P-clip cable around the DC cable, and then fasten it to the Access
Point chassis using one of the short machine screws supplied with the Access Point.
f. Wrap the green rubber O-ring around the DC cable, and then place the wrapped
section into the right cable groove.
Ground Wire to
V- Terminal
12V DC Wire to
V+ Terminal