User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
36
Connecting to the Network
Step 2: Attach the Dynamic Bracket to the Access Point
6. Connect the power jack to the DC 48V IN connector on the PoE injector, and then
plug the power adapter to a power source. Verify that the PWR LED on the back of the
Access Point is steady green.
Figure 23. Connect the Ethernet cables and power adapter to the PoE injector
7. Wrap the white P-clip cable clamp around the Ethernet cable, and then fasten it to the
Access Point chassis using one of the short machine screws supplied with the Access
Point.
8. Wrap the black rubber O-ring around the Ethernet cable, and then place the wrapped
section into the left cable groove. The black rubber O-ring can support 5.6mm to
6.0mm cable.
To A C
Power
Source
To Access
Point
To Admin
Computer