User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
35
Connecting to the Network
Step 2: Attach the Dynamic Bracket to the Access Point
6 Connecting to the Network
For guidance on the connections required for typical installations, refer to Figure 22.
Figure 22. Typical installation components using PoE as the only power source
WARNING: Do not apply power to the Access Point until you finish connecting all other
components.
1. Verify that the RJ45 port on the AP is connected to the PoE OUT port on the PoE
injector.
2. Connect the Ethernet cable from the 10/100 DATA IN port on PoE injector to your
network router or switch.
3. Apply power to the Access Point.
4. Continue to “Attaching the Mounting Brackets”
.
5. Connect one end of the other Ethernet cable to the PoE OUT port on the PoE injector,
and then connect the other end to the RJ45 port on the Access Point.
OUTDOOR
INDOOR
Access Point
Ethernet Surge
Protector
PoE Injector
Router or Switch
Power Adapter
Drip Loop