User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
33
Attaching the Mounting Brackets
Step 2: Attach the Dynamic Bracket to the Access Point
Figure 20. Position and fasten the metal plates to the Access Point
3. Place the dynamic bracket on top of the metal plates. Make sure that:
• The screw holes on the bracket align with the remaining screw holes on the metal
plates.
• The curved mounting hole is on the same side as the LEDs.
4. Insert and fasten a machine screw (supplied) into each of the four screw holes.