User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
32
Attaching the Mounting Brackets
Step 2: Attach the Dynamic Bracket to the Access Point
Figure 19. Tighten the four machine screws to fasten the bracket to the Access Point
4. Continue to “Connecting to the Network”
on page 35.
Mounting on a Horizontal Pole
1. Place the two metal plates horizontally on the flat side of the Access Point, as shown
in Figure 1
. Make sure that the screw holes on the metal plates align with the screw
holes on the Access Point.
2. Insert and fasten a machine screw (supplied) into each of the four screw holes.