User Manual

31
Attaching the Mounting Brackets
Step 2: Attach the Dynamic Bracket to the Access Point
3. Using a 10mm flathead screwdriver, tighten the clamp lock to secure the bracket to the
pole.
Figure 18. Tighten the clamp lock to secure the bracket
4. Continue to “Step 2: Attach the Dynamic Bracket to the Access Point”
.
Step 2: Attach the Dynamic Bracket to the Access
Point
The procedure for attaching the dynamic bracket to the Access Point depends on whether
you are mounting the Access Point on a flat surface/vertical pole or on a horizontal pole.
If you are mounting the Access Point on a horizontal pole, you will need to install the two
metal bars that are supplied with the Access Point.
Mounting on a Flat Surface or Vertical Pole
1. Place the dynamic bracket onto the flat side of the Access Point so that the four screw
holes on the bracket align with the four screw holes on the Access Point. Make sure
that the shorter end of the mounting bracket is on the same side as the antenna
connector.
2. Insert four machine screws (supplied with the Access Point) into the screw holes.
3. Tighten the four machine screws using a 6mm Phillips screwdriver.