User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
28
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
Figure 15. Use hex nuts to attach the bracket to the surface
9. Using a 10mm open-end wrench, tighten the nuts to secure the bracket to the
mounting surface. As you tighten the nuts, the metal cones that are built into the wall
anchors will expand and lock the wall anchors into place.
10. Continue to “Step 2: Attach the Dynamic Bracket to the Access Point”
.
Attaching the Bracket to a Pole
The Access Point can be mounted vertically or horizontally on a 30mm to 60mm (1.18 in.
to 2.36 in.) pole.
1. Insert the open end of the steel clamp into the two tabs on the bracket.