User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
27
Attaching the Mounting Brackets
Step 1: Attach the Static Bracket to the Mounting Surface
3. Remove the static bracket from the mounting surface.
4. Drill an 8mm-diameter hole with a depth of 36mm-38mm into each of the markings
that you made on the mounting surface.
5. Insert a wall anchor (with the unthreaded part first) into each of the holes that you
drilled.
6. Place a fender washer on each screw.
7. Align the two screw holes on the bracket with the wall anchors that you inserted earlier.
Figure 14. Align the screw holes on the bracket with the wall anchors
8. Use two hex nuts to attach the bracket to the mounting surface.