User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
25
Attaching the Mounting Brackets
What You Will Need
5 Attaching the Mounting Brackets
What You Will Need
To complete this procedure, you will need the following items:
■ Static bracket
■ Dynamic bracket
■ Wall anchors
■ Fender washers
■ Hex nuts
■ 10mm ratchet wrench
If you are mounting the Access Point on a flat surface, you will also need an electric drill
with an 8mm drill bit.
If you are mounting the Access Point on a pipe or pole, you will also need the following:
■ A 30mm to 60 mm (1.18 in. to 2.36 in.) pipe or pole
■ Steel clamp
■ 10mm flathead screwdriver
For mounting on a horizontal pole, you will need the two metal bars that are supplied with
the Access Point.
NOTE: Do not mount the Access Point after you finish attaching the mounting brackets.
Ruckus Wireless strongly recommends that you first connect the Access Point to the
network, and then test it first before finally mounting it to your desired location.