User Manual
Table Of Contents
- Contents
- 1 About This Getting Started Guide
- 2 Unpacking the ZoneFlex Access Point
- 3 Before You Begin
- 4 Configuring the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- Step 1: Prepare the Administrative Computer
- Step 2: Connect the Access Point to the Administrative Computer
- Step 3: Log Into the Access Point’s Web Interface
- Step 4: Configure the Wireless Settings
- Step 5: Disconnect the Access Point from the Administrative Computer
- Step 6: Restore the Administrative Computer’s Network Settings
- 5 Attaching the Mounting Brackets
- 6 Connecting to the Network
- 7 Verifying the Installation
- 8 Joining the Mounting Brackets
- 9 (Optional) Mounting and Connecting the External Antenna
- 10 What to Do Next
- 11 Professional Installation Instructions
20
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
Configure Common Wireless Settings
1. On the left menu of the Web interface, click Configuration > Wireless. The Common
page appears.
2. Verify that the common wireless settings are configured as listed in Table 5
.
3. If you made any changes to the Common tab, click Update Settings.
4. Continue to “Configure Wireless # Settings”
below.
Figure 10. The Configuration > Wireless > Common tab
Table 5. Common wireless configuration
Setting Recommended Value
Wireless Mode Auto-select
Channel SmartSelect
Country Code • If you purchased the Access Point in the United
States, this value is fixed to United States at the
factory and is not user configurable.
• If you purchased the Access Point outside the
United States, verify that the value is set to your
country or region. Selecting the correct country
code ensures that the Access Point uses only the
radio channels allowed in your country or region.