User Manual

18
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
Figure 8. Connect the ground wire to the V- terminal and the +12v DC wire to the V+
terminal
5. Using a 3mm Phillips screw, tighten the wiring terminal screws.
6. Connect the DC terminal block to the 12V DC port on the Access Point.
7. Connect the DC cable to a DC power source (for example, a battery).
You have completed connecting the Access Point to the administrative computer and to
a DC power source.
Step 3: Log Into the Access Point’s Web Interface
1. On the administrative computer, open a Web browser window.
2. In the address or location bar, type the following address:
https://192.168.0.1
3. Press <Enter> on the keyboard to connect to the Access Point’s Web interface. A
security alert message appears.
4. Click Yes or OK (depending on the browser) to continue. The Access Point’s login page
appears.
Ground Wire to
V- Terminal
12V DC Wire to
V+ Terminal