User Manual

17
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
4. Connect the power jack to the DC 48V IN connector on the PoE injector, and then
plug the power adapter to a power source. Verify that the PWR LED on the back of the
Access Point is steady green.
NOTE: If the power outlet in your installation environment is three-pronged, use the two-
prong plug adapter that is shipped with the Access Point.
Figure 7. Connect the Ethernet cables and power adapter to the PoE injector
You have completed connecting the Access Point to the administrative computer and to
a PoE power source.
Use DC Power
To use DC to power the Access Point, you need to connect a DC cable (not supplied with
the Access Point) to the DC terminal block.
1. Connect one end of an Ethernet cable to the RJ45 port on the Access Point, and then
connect the other end to the administrative computer’s Ethernet port.
2. Take out the DC terminal block from the small plastic bag that contains the bottom
cover of the Access Point.
3. Connect the DC cable’s ground wire to V- terminal. If you are looking at the terminal
block with the wiring terminal screws on top, the V- terminal is on the left side.
4. Connect the DC cable’s +12v DC wire to the V+ terminal. If you are looking at the
terminal block with the wiring terminal screws on top, the V+ terminal is on the right
side.
To A C
Power
Source
To Access
Point
To Admin
Computer