User Manual

EnGenius Mesh AP-EOA-8670 User Manual & Configuration Guide
EnGenius Mesh AP-EOA-8670 User Manual & Configuration Guide
Page 21 of 67
5.4 Network > Wireless
Figure 5.4.1 illustrates the AP configuration page.
Figure 5.4.1: AP configuration page
Wireless AP contains the following parameters:
• MAC address – Displays the MAC address of the wireless interface.
• Mode – Only AP mode is available in MAP 4000.
• Band – “802.11a”, “802.11b” or “802.11g” operating band.
• Frequency – Operating frequency of the wireless network in Ghz.
• Tx antenna – Select “Diversity”, “Port 1”, “Port 2” or “Card Default”.
• Rx antenna – Select “Diversity”, “Port 1”, “Port 2” or “Card Default”.
• Current Maximum Tx Power – Displays current transmit power of the
wireless card due to regulatory limitation.
• Maximum Tx Power (dBm) – Select transmit power of the AP wireless card.
• “Apply” button to save any changes made. New settings are active after the