User's Manual

2.2 Installation
To install the ENH700EXT, use the following procedure and refer to the figure below.
1. Connect the 4 dipole antennas to the top and bottom of the ENH700EXT and tighten
them by hand.
2. Connect either end of an Ethernet cable to the ENH700EXT jack labeled RJ-45. Connect
the other end of the cable to the RJ-45 jack on the PoE adapter labeled AP/Bridge
Network.
3. Attach the round plug on the supplied power adapter to the DC48 V IN connector on the
Power on Ethernet adapter. Connect the other end to a working AC outlet. The red LED
on the PoE adapter goes ON to show it is receiving AC power.
WARNING: Only use the power adapter supplied with the ENH700EXT. Using a different power
adapter can damage the ENH700EXT.
2.3 Understanding the ENH700EXT LEDs