User's Manual

Apply / Cancel

Click Apply to apply the changes or Cancel to discard your changes and return to the

previous settings.

7.3 PPPoE (Point-to-Point Protocol over Ethernet)

Select Point to Point Protocol over Ethernet (PPPoE) if  your ISP uses a PPPoE connection. Your ISP

will provide you with a username and password. This option is typically used for DSL services.

Remove your PPPoE software from your computer, as it is not needed and will not work with your

ENH700EXT.

Specify the user name supplied by your ISP.

Password

Specify the password supplied by your ISP.

Service Name

Specify the service name supplied by your ISP.

MTU

Specify the Maximum Transmit Unit size. It is recommended you accept the default

setting of Auto. Otherwise, packets will be fragmented downstream if the MTU is set

too high or too low, which impacts network performance. In extreme cases, an MTU

setting that is too low can prevent the ENH700EXT from establishing some

connections.

Authentication Type

Select the algorithm used for authentication. Choices are PAP, CHAP, or Auto.

Default is Auto.

Type

Select a connection type from the drop-down menu. Choices are:

•

Keep Connection = device connects to the Internet automatically.

•

Automatic Connection = device connects to the Internet automatically when the

traffic goes through the Internet and disconnects after a period of idle time

elapses.

•

Manual Connection = device connects to the Internet manually.

Idle Timeout

If the ENH700EXT is configured for Automatic Connection, specify the maximum