User's Manual
Table Of Contents
- 1 Product Overview
- 2 Installation
- This chapter describes how to install the ENH500.
- Select the optimal locations for the equipment using the following guidelines:
- 3 Wireless Network Modes
- 4 Configuring Your Computer for TCP/IP
- 5 Status
- 6 System
- 7 Wireless Configuration
- 8 LAN Setup
- 9 Router Settings
- 10 Management Settings
- 11 Network Configuration Examples
- Appendix A – Troubleshooting
- Appendix B – Specifications
- Appendix C – Glossary
- Appendix D – Statements of Conformity
4.4 Configuring Apple Mac OS X
The following procedure describes how to configure TCP/IP on an Apple Macintosh running
Mac OS 10.2 or later. Note: The menu titles and placement vary in each OS X 10.x operating
system but are typically similar.
1. Pull down the Apple Menu, click System Preferences, and select Network.
2. Verify that the NIC connected to the ENH500 is selected in the Show field.
3. In the Configure field on the TCP/IP tab, select Manually.
4. Click Apply Now to apply your settings and close the TCP/IP dialog box.
5. Enter an IP address (i.e. 192.168.1.10), the subnet mask of the ENH500, and the Router
which is the ENH500’s IP address, 192.168.1.1. Note: the subnet mask must match that of
the ENH500 and the IP address must be on that subnet.
6. Click Apply Now to apply your settings and close the TCP/IP dialog box.