User's Manual
Table Of Contents
- Contents
- Chapter 1: Regulatory Compliance Statements
- Federal Communications Commission (FCC) Compliance Notices
- Class B Interference Statement
- FCC Caution
- RF Radiation Exposure and Hazard Statement
- Non-Modification Statement
- Deployment Statement
- Outdoor operating restrictions
- Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands
- Canadian IC Statements
- European Union and European Free Trade Association (EFTA) Regulatory Compliance
- Declaration of Conformity
- European Community Declaration of Conformity
- Countries of Operation and Restrictions of Use in the European Community
- Operation Using the 2.400 to 2.4835 GHz Channels in the European Community
- Operation Using the 5.15 to 5.25 GHz, 5.25 to 5.35 GHz, and 5.470 to 5.725 GHz Channels in the European Community
- Russia, Belarus, and Kazakhstan Requirement
- Antenna Statement
- Chapter 2: Devices with detachable antennas
- Chapter 3: English
- Kapitel 4: Deutsch
- Einführung
- Sicherheitsmaßnahmen
- Installation des WLAN-AP 8120-O
- Hardware
- Kabelanschlüsse
- Abdichten des Ethernet-UTP-Kabels
- Mounten eines WLAN-AP 8120-O an einem vertikalen Mast
- Mounten eines WLAN-AP 8120-O an einem horizontalen Mast
- Mounten eines WLAN-AP 8120-O an einer Wand
- Installation des Ethernet-Überspannungsableiters
- Installation des Power over Ethernet-Injektors
- Sicherheitshinweise
- Capítulo 5: Español
- Introducción
- Precauciones de seguridad
- Instalación del WLAN AP 8120-O
- Hardware
- Requisitos de cableado
- Impermeabilización del cable UTP Ethernet
- Instalación del WLAN AP 8120-O en un poste vertical
- Montaje del WLAN AP 8120-O en un poste horizontal
- Instalación del WLAN AP 8120-O en una pared
- Instalación del disipador de sobretensiones Ethernet
- Instalación del inyector Power over Ethernet
- Advertencias de seguridad
- Chapitre 6 : Français
- Capítulo 7: Português do Brasil
Specification Description
Surge protection Meets surge protection as specified in GR-1089-Core Criteria
B:
• ± 1000V/100A @ 10/1000 [μS] Waveform
•
± 2500V/500A @ 2/10 [μS] Waveform
• ± 1000V/25A @ 10/360 [μS] Waveform
About this task
To install the Power over Ethernet to the WLAN AP 8120-O , complete the following:
Procedure
1. Before connecting the Power on Ethernet adapter to the WLAN AP 8120-O you
must first ground the PoE. To ground and connect the PoE to the WLAN AP 8120-
O, complete the following:
a. Connect one end of the green grounding wire to the protruding copper ground
post on the bottom of the PoE.
b. Connect the other end of the ground wire to an acceptable Earth ground.
2. Attach the supplied power plug to the three-prong plug outlet on the bottom of the
PoE adapter.
Figure 21: Copper ground post on PoE
3. Connect the other end to a working AC outlet.
4. Insert one end of an Ethernet cable into the DAT
A IN port on the PoE adapter.
English
44 Avaya WLAN 8100 Regulatory Information — WLAN AP 8120-O February 2012
Comments? infodev@avaya.com