User's Manual
Table Of Contents
- Contents
- Chapter 1: Regulatory Compliance Statements
- Federal Communications Commission (FCC) Compliance Notices
- Class B Interference Statement
- FCC Caution
- RF Radiation Exposure and Hazard Statement
- Non-Modification Statement
- Deployment Statement
- Outdoor operating restrictions
- Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands
- Canadian IC Statements
- European Union and European Free Trade Association (EFTA) Regulatory Compliance
- Declaration of Conformity
- European Community Declaration of Conformity
- Countries of Operation and Restrictions of Use in the European Community
- Operation Using the 2.400 to 2.4835 GHz Channels in the European Community
- Operation Using the 5.15 to 5.25 GHz, 5.25 to 5.35 GHz, and 5.470 to 5.725 GHz Channels in the European Community
- Russia, Belarus, and Kazakhstan Requirement
- Antenna Statement
- Chapter 2: Devices with detachable antennas
- Chapter 3: English
- Kapitel 4: Deutsch
- Einführung
- Sicherheitsmaßnahmen
- Installation des WLAN-AP 8120-O
- Hardware
- Kabelanschlüsse
- Abdichten des Ethernet-UTP-Kabels
- Mounten eines WLAN-AP 8120-O an einem vertikalen Mast
- Mounten eines WLAN-AP 8120-O an einem horizontalen Mast
- Mounten eines WLAN-AP 8120-O an einer Wand
- Installation des Ethernet-Überspannungsableiters
- Installation des Power over Ethernet-Injektors
- Sicherheitshinweise
- Capítulo 5: Español
- Introducción
- Precauciones de seguridad
- Instalación del WLAN AP 8120-O
- Hardware
- Requisitos de cableado
- Impermeabilización del cable UTP Ethernet
- Instalación del WLAN AP 8120-O en un poste vertical
- Montaje del WLAN AP 8120-O en un poste horizontal
- Instalación del WLAN AP 8120-O en una pared
- Instalación del disipador de sobretensiones Ethernet
- Instalación del inyector Power over Ethernet
- Advertencias de seguridad
- Chapitre 6 : Français
- Capítulo 7: Português do Brasil
Avaya strongly recommends that you use an outdoor CAT-5E Ethernet cable for all external
connections.
The AP8120-O supports 802.3at (also known as PoE+). Avaya recommends that you use an
Avaya-provided PoE power injector when operating the AP8120-O. The access point receives
power and data through the RJ-45 port. Refer to Installing the Power over Ethernet injector on
page 43 for more information.
The Ethernet port on the access point cannot accept a cable that has an uneven sheath as
shown below. With an uneven
sheath, the RJ-45 connector on the cable will not seat properly
in the receptacle on the access point. Use a cable with an even sheath instead.
Figure 1: CAT-5 connector showing uneven sheath
Waterproofing the Ethernet UTP cable
Before connecting the outdoor Ethernet cable to the WLAN
AP
8120-O you must first
waterproof the Ethernet UTP
cable or risk an electrical shock.
T
o waterproof the Ethernet cable, complete the following procedure:
Note:
Avaya recommends using only an certified outdoor UTP cable such as a CAT-5E cable.
Procedure
1.
Unscrew the waterproof feed through cap and extract the grommet seal.
2. Slide the Ethernet UTP cable through the compression cap, the grommet seal, and
the Ethernet feed through body.
3. Strip the end of the Ethernet UTP cable to the length required for the 8P8C plug.
4. Insert the stripped end of the cable into the plug following either EIA/TIA 568A or
568B wiring as listed in the following table. Ensure that both ends of the cable have
the same pinout for the RJ45 connectors.
5. Crimp the 8P8C connector to the cable.
Installing the WLAN AP 8120-O
Avaya WLAN 8100 Regulatory Information — WLAN AP 8120-O February 2012 23