User's Manual

Hardware
The installation kit contains the following:
• 1 Avaya WLAN AP8120-O access point
•
1 Mounting kit:
- 1 plane bracket
- 2 brackets for base
- 2 hose straps – 2.5" and 5" diameter
- 4 bolts
- 4 roundhead
- 8 hexcap screws
• 1 Ethernet surge arrester
• 1 grommet for waterproofing the Ethernet connection on the access point
• 2 x 2.4 GHz antennas
• 2 x 5 GHz antennas
Equipment heat and cold loading requirements
The WLAN 8100 AP 8120-O must operate between -40 to +55℃.
Cable requirements
Before connecting the AP 8120-O with an Ethernet UTP
cable you must ensure that the cable
has been properly waterproofed for out door use. For instructions on how to waterproof the
Ethernet UTP cable, see
Waterproofing the Ethernet UTP cable on page 23.
Warning:
You must use a certified outdoor UTP cable or risk injury from electrical shock.
Note:
Avaya recommends using only a certified outdoor UTP cable such as the Cat5E.
The AP 8120-O access point has one RJ-45 port that provides a 10/100/1000BASE-TX
Ethernet connection that is used to indirectly connect the access point to an A
vaya WC 8180
WLAN controller, typically through an intermediate Layer 2 or Layer 3 network. When
connecting an outdoor access point, use a Category 5e (CAT-5e) cable with straight-through
signaling and standard RJ-45 connectors to connect to a network device.
English
22 Avaya WLAN 8100 Regulatory Information — WLAN AP 8120-O February 2012
Comments? [e-mail]