User Manual

▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
Basic Operation
Auto Frequency Scanning (AFS)
1. Power on the receiver and transmitter.
2. Press and hold the AFS button
on the receiver to initiate a
frequency scan. The receiver will
scan all available frequencies
and select one that is free of
interference, [
SCANNING ] will appear on the screen. Once
the scan is complete,
[ SYNC >>> ] will appear on the screen, and the receiver will
automatically send out a sync signal from its IR port.
3. Position the transmitter and receiver so their IR ports face
each other. [
SYNC  ] will appear on the receiver’s screen
when the devices have been successfully synced.
If [ SYNC ERROR! ] appears on the screen, rescan by pressing
and holding the AFS button again. Make sure the transmitter
is turned on and that the IR ports are facing each other.
Note: The receiver sends an IR sync signal for approximately
10 seconds. If syncing is not accomplished in that time, you
can restart the process by pressing and holding the AFS
button again.
Manual Sync
To manually sync the receiver and transmitter to the same
frequencies, follow these steps:
1. On the receiver, press and hold the Set button to enter
the menu.
2. Use the Up/Down arrow buttons to scroll to
[ ADVANCED MENU ]. Press Set to enter the advanced menu.
3. Use the Up/Down buttons to scroll to [
SYNC ], and
press Set.
14