User Manual

9
Setting Up
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
You can adjust the high frequency (HF) by ±1 dB and the low
frequency (LF) by ±2 dB. We recommend adjusting these to
suit the listening environment.
You can adjust the mid frequency (MF) by
-2 and -4 dB. We recommend adjusting
these to suit your speaker placement.
When the speaker is placed on a stand or
mounted on a wall, we recommend setting
the MF switch to 0. When the speaker is
placed on a desk or table and its face is
3.1″ to 9.8″ (8 to 25 cm) from the edge of
the desk, we recommend setting the MF
switch to -2. When the speaker is more than
9.8″ (25 cm) from the edge of the desk,
we recommend setting the MF switch to
-4. These measurements are approximate
and will depend on your specific listening
environment.
You can adjust the high-pass (HP) filter to
cut off low frequencies at 38, 48, and 58
Hz. This feature is ideal when matching the
speaker with a subwoofer. When using the
speaker in pairs, we recommend setting the
HP switch to 38 Hz.
The frequency adjust terminal is for testing and adjusting the
curve. It had been adjusted in an anechoic chamber to its
optimal position, and we strongly recommended that you do
not adjust this setting.
38Hz
48Hz
58Hz
+2
-2
38Hz
48Hz
58Hz
+2
-2
38Hz
48Hz
58Hz
+2
-2
38Hz
48Hz
58Hz
+2
-2