Instruction Manual

ManualsBrandsSENADA BIKES ManualsDigital DisplaySENADA BIKES LYNX Digital Display

LYNX Digital Display Operating Instructions

Dear customer, thanks for purchasing LYNX, please read the instruction below carefully

and thoroughly, it will guide you in operating the LCD display correctly.

A. Function and Display

ASSIST

Gear switch

Km/h

Real-time riding speed (km)

Remaining battery display

MPH

Real-time riding speed (mile)

Headlight on symbol

MXS

Single time highest riding speed

Brake

AVS

Single time average riding speed

CRUISE

Cruise

Riding mileage (km)

PAS

Paddle assist

Mil

Riding mileage (mile)

THROTTLE

Throttle on symbol

ODO

Odometer display

Single riding time

VOL

Battery voltage display

TTM

Accumulated riding time

DST

Single time riding mileage

Walk assist mode

(not applied on LYNX)

Summary of content (4 pages)

PAGE 1
LYNX Digital Display Operating Instructions Dear customer, thanks for purchasing LYNX, please read the instruction below carefully and thoroughly, it will guide you in operating the LCD display correctly. A.
PAGE 2
B. Function Operation 1. Turn On and Off Long press button to turn on the display; long press button again to turn it off. The display will turn off automatically when the e-bike stops and no further options for 5 minutes (auto turn off time can be adjusted). 2. Main Interface The main interface of the display looks like this: 2.1 Turn on the headlight At the main interface, long press turn on the headlight; long press again to turn it off: button to button 2.
PAGE 3
2.5 Auto prompt message (error message) Error message definition: E-01 Motor malfunction E-02 Throttle malfunction E-03 Controller malfunction E-05 Controller under voltage E-06 Communication failure, display cannot receive the signal from controller *If there is any errors, feel free to reaching out to our support team at contact@senadabikes.com, we are here to help! Please also send us some photos/videos of the issue. 3.
PAGE 4
P14: Controller current limit setting, range 1A to 20A P15: N/A P16: N/A P17: Cruise setting, 0 is cruise off, 1 is cruise on *Factory settings: P01 3 P02 0 P03 48 P04 5 P05 5 P06 20 P07 1 P08 99 P09 P10 P11 P12 P13 P14 P15 P16 P17 0 2 3 5 5 12 41 real time ODO 1 4. Tips about the battery 1. Please fully charge the battery when you first receive the bike. 2. Keep the battery at a dry place, keep the temperature around 32°f to 68°f.