Operation Manual

SMH10

3. If you have any problem to clamp the Speaker-Microphone unit on the helmet

for any reason, you may use the glued surface mounting adaptor to attach the

Speaker-Microphone unit on the external surface of the helmet.

• Remove the back plate of the Speaker-Microphone clamp unit by loosening the

two screws with the enclosed Hex Key.

• Attach the glued external adaptor to the Speaker-Microphone clamp unit by

tightening the two screws instead of the removed back plate.

• Locate a proper surface on the helmet to attach the unit, clean the helmet surface

location with a moistened towel, and allow to dry thoroughly.

• Peel off the cover of the adhesive tape of the adaptor and attach the unit on the

proper surface of your helmet.

Sena recommends the clamp unit over the glued surface mounting adaptor. Even though

the glued surface mounting adaptor is provided for convenience, Sena does not assume

any responsibility for use of it. Users may have to use the glued adaptor at their own risk

and responsibility.

Warning:

4. Attach the headset main unit to the Speaker-Microphone clamp unit. Insert the

bottom part of the main unit completely into the lower slot of the clamp unit first.

Then push the upper part of the main unit until it clicks into the upper holder of

the clamp unit.

Attach