User Guide

SD1000

Quick Start Guide

www.sena.com

To make a pair

Serial Port Setting

Bluetooth Serial Adapter

Configuration using software

Quick Pairing between the Parani devices

If users want to configure and to connect step by step with diagnosis

messages, then they may use either ParaniWin or Hyper terminal

program. The Parani-SD1000 supports AT command set for versatile

operations.

Parani-SD1000 default configuration is 9600 bps Baud, 8 Data bits, No

Parity, 1 Stop bit and Hardware flow control.

For more information, refer to the User Manual.

You may download the ParaniWin and User Manual

from CD or Sena website at

http://www.sena.com/support/downloads/

Step 1. Turn on SD1 and SD2, then Press the Factory Reset Button respectively.

Step 2. Press the Pairing Button of SD1 for 2 seconds until Mode LED blinks 3

times every 3 seconds. Keep the power ON.

Step 3. Press the Pairing Button of SD2 for 2 seconds until Mode LED blinks 3

times every 3 seconds. Now press the Pairing Button again for 2 seconds until

Mode LED blinks every second.

Step 4. Wait for SD1 & SD2 to connect to each other until the Connect LED’s of

SD1 and SD2 blink every 1 second. It takes about 10 seconds to make a connec-

tion. If there are many Bluetooth devices nearby, it may take longer.

Step 5. Turn SD1 off and on. Mode LED blinks 3 times in green every 3 seconds.

Step 6. Turn SD2 off and on. Mode LED blinks in green every second.

Now SD1 and SD2 are configured to make automatic connection to each

other, whenever they are powered on.

Parani-SD provides Pairing Button for instant configuration without a PC

to make an automatic connection between two Parani-SDs. We will refer

to the two Parani-SDs as SD1 and SD2, respectively. In pairing status, SD

changes IAC value automatically.

There are four DIP switches for serial port configuration. The upper 3 are

for setting baud rate, and the last one in the bottom is for setting hardware

flow control option. To put the switch to left side represents OFF, and the

right side ON. To disable hardware-based baud rate configuration, set up

the DIP switch to “S/W config”. In this case, the software configuration

value will replace the one in the DIP switch. The default value of “S/W

config” Setup is 9600 bps.

Visit us at www.sena.com

PAGE 1
Quick Start Guide SD1000 Bluetooth Serial Adapter www.sena.com To make a pair Quick Pairing between the Parani devices Step 1. Turn on SD1 and SD2, then Press the Factory Reset Button respectively. Step 2. Press the Pairing Button of SD1 for 2 seconds until Mode LED blinks 3 times every 3 seconds. Keep the power ON. Step 3. Press the Pairing Button of SD2 for 2 seconds until Mode LED blinks 3 times every 3 seconds. Now press the Pairing Button again for 2 seconds until Mode LED blinks every second.