User guide

98
<ESC> Back, <ENTER> Refresh
----->1
Enter Current Data(mm/dd/yy) : 05/20/05
Press the ENTER key to continue!!
-----------------------------------------------------------------------------
RTC Configuration
-----------------------------------------------------------------------------
Select Menu
1. Data(mm/dd/yy) : 05/20/05
2. Time(hh:mm:ss) : 15:02:41
<ESC> Back, <ENTER> Refresh
----->2
Enter Current Data(hh:mm:ss) : 15:03:40
Press the ENTER key to continue!!
-----------------------------------------------------------------------------
RTC Configuration
-----------------------------------------------------------------------------
Select Menu
1. Data(mm/dd/yy) : 05/20/05
2. Time(hh:mm:ss) : 15:03:41
<ESC> Back, <ENTER> Refresh
----->
Figure A-10 RTC configuration within Bios Menu Program
A 4.4. Hardware test menu
Using the Hardware test menu, the user can test hardware components. There are three hardware
test modes:
- One time
- Looping (without External test in Auto test)
- Looping (with External test in Auto test)
If the user selects One time, an auto test or each component test is performed just once. In this mode,
the ping test to the remote host (server IP address) and UART test are also performed once.
If the user selects Looping (without External test in Auto test), the auto test is performed repeatedly
until the user presses the <ctrl-c> keys. In this mode, the ping test to the remote host (server IP
address) and UART test are not performed.
If the user selects Looping (with External test in Auto test)’, auto test is performed repeatedly until the
user presses the <ctrl-c> keys. And, the ping test to the remote host (server IP address) and UART
test are also performed repeatedly.
Note:
To perform the test on the Ethernet and UART properly, the user must connect an Ethernet cable to
the Ethernet port of the Pro Series and must plug the loopback connector to all the serial ports of the
Pro Series. There must exist a remote host with a valid IP address. The default server IP address is
192.168.0.128 and it can be changed using the [Firmware Upgrade] menu. Otherwise, the test may
not be performed properly.