User guide

13
Figure 2-1 The panel layout of the PS110
2.1.2. PS410/810 Panel Layout
The PS410/810 has three groups of LED indicator lamps to display the status, as shown in Figure 2-2
and Figure 2-3 (i.e. System, Ethernet and Serial ports). The first two lamps on the left side indicate
Power, Ready(PS810 only). The next two lamps are for Ethernet Link and Act. Next lamps indicate
Receive and Transmit of the serial port. Table 2-2 describes the function of each LED indicator lamp.
Table 2-2 LED indicator lamps of the PS410/810
Lamps Function
Power Turned on if power is suppliedSystem
Ready Turned on if system is ready to run (PS810 only)
LINK Turned on if connected to Ethernet networkEthernet
Act Blinks whenever there is any activities such as incoming or outgoing
packets through the Pro Series Ethernet port
Rx Blinks whenever there is any incoming data stream through the serial port of
the Pro Series
Serial port
Tx Blinks whenever there is any outgoing data stream through the serial port of
the Pro Series
There is a factory reset switch near by Serial console port and user can use this switch to restore
factory default configuration.
For PS410 there are 4 DIP switches to set communication type of serial port. (Please refer to Section
4.2.6 and Appendix A for more detail information of serial communication type and its connection)