Quick start manual

STER PMU Quick Start Manual Using the Wamster web interface
34
1
2
3
Figure 6.4: Visual status indicators and command buttons
Visual status indicators and command buttons:
1
Status indicators
First row of indicators shows statuses:
 ONLINE: when green, device is connected
 GPS: when green, GPS reliable
 SD: when green, SD card inserted and functional
Second row of indicators blink to indicate that the communication is live:
 NEW: if green, up-to-date synchrophasor frame received
 
 REQ: if orange, there is a pending request for old frames (either because of
a bad data connection, or because user requested frames at a different
reporting rate)
2
Device Settings
button
Clicking on this button opens the Device Settings form, which can be used to
configure the device
3
Remote Access
button
Clicking on this button shows the Remote Access page, which can be used to connect
to the instrument and operate it remotely
To change the custom name of a device and its reporting frequency, click on the Device Settings button to open
the Device Settings form:
Figure 6.5: Device Settings form can be used to change the name of the device
and its reporting frequency
When finished, click Ok to accept settings.
Some settings (like reporting speed, for example) might appear unchanged for several seconds after the
dialog is closed, until the remote device receives them.
Note also that the form contains Measurement setup settings intended to allow post processing (scaling
and phase swapping) of signals. This feature is currently reserved for future use and can be enabled on
request.