Quick start manual

STER PMU Quick Start Manual Getting started
19
3.3 CONFIGURING THE DEVICE FOR FIRST USE
3.3.1 MAIN SCREEN
After powering on, main device screen is shown:
1 2 3 4
5
6
Figure 3.17: Startup screen
Main screen components:
1
Battery status
Displays current battery voltage and charging status
2
GPS status
GPS synchronization status:
 NO RCV: cable disconnected
 RCV: cable connected, but not synchronized
 PPS: synchronized but not reliable
 PPS&A: synchronized and reliable
3
Communication
status
WAMSTER communication status:
 DISABLED: communication disabled
 INIT: initialization in progress
 SET CONN: configuring server address and port
 CONNECTING: trying to connect to the server
 CONNECTED: connection established
4
Date and time
Current time and date (hh:mm:ss DD.MM.YY). Time is synchronized through the GPS
received, once the GPS status is PPS&A.
5
Soft function keys
Generally, these are indications of submenus or actions for each of the four function
keys ( , , , ). In the main screen, they represent main submenus:
 METER: displays the Meter screen, used to monitor measurements
 STATUS: displays the Status screen, showing system status
 SETUP: displays the Setup screen, used for configuring the device
6
Device ID
Shows the device ID when connected to the Wamster network. Each device has a
unique ID. This ID cannot be changed.
Note that the bottom bar in the startup screen displays three Soft function keys: METER, STATUS and SETUP. These
function can be accessed by pressing , and function keys, respectively. It is possible return to the
main menu from any sub menu by pressing the Esc key ( ) repeatedly.
3.3.2 SETUP MENU
To enter the Setup menu, press the function key while located in the startup screen: