Quick start manual
STER PMU Quick Start Manual Getting started
18
It is presumed that configuration of the modem has been completed before continuing with this chapter. If
not, please refer to chapter 3.1 Configuring the Serial to Ethernet converter.
Check that the Data/Console switch at the PS110 device is switched to Data mode before continuing.
First, connect the GPS receiver by plugging the PS2 connector into the middle PS2 socket at the side panel of the
STER PMU device. Connect the second part of this cable to the power socket on the SENA PS110 device.
PS2 male
connector
Power
connector
USB
Switched to
Data mode
USB
DB9 female
DB9 male
DB9 female
GPS receiver
PS2
Figure 3.15: Connecting the GPS receiver and the Serial to Ethernet converter power supply
Next, use the two provided cables (USB to DB9M and DB9F to DB9F) to connect the STER PMU device to the serial
port of the SENA PS110 device, as shown below:
USB
Switched to
Data mode
USB
DB9 female
DB9 male
DB9 female
PS2 male
connector
GPS receiver
Figure 3.16: Connecting the serial cable to the PS110 converter