Quick start manual

STER PMU Quick Start Manual Getting started
16
Figure 3.12: Serial port parameters
12. Save and apply changes by entering the save command, followed by the apply command. The device will
save new configuration settings in the non-volatile memory and apply them.
13. Finally, exit from the text-driven configuration menu interface by entering the exit command.
Figure 3.13: Save, apply and exit to finish configuration
14. When finished, disconnect the serial cable and move the Data/Console switch to Data position. Modem is
now ready to be connected to the device.
3.1.3 CONFIGURING THE SERIAL TO ETHERNET CONVERTER THROUGH THE WEB
INTERFACE
To configure Serial to Ethernet converter through the web interface please refer to the SENA PS110 user manual
on the accompanied CD-ROM.