Quick start manual

STER PMU Quick Start Manual Getting started
15
Figure 3.10: Serial port configuration overview
In the serial port configuration overview select the ordinal number of the serial port to configure. On a PS110,
there will only be a single port shown. Press 1 and Enter to configure the port, then enter the Host mode
configuration menu.
11.1. Host mode configuration
Host mode configuration parameters should match the following table:
Host mode
Modem emulation
Command echo delay
0
Default echo mode
Disable
Default data mode
Raw TCP
Once set, the Host mode configuration menu should appear as shown on the picture below:
Figure 3.11: Host mode configuration parameters
11.2. Serial port parameters
Several Serial port parameters have to be changed as follows:
Baud rate
115200
Inter character time-out
0
Other parameters should be left unchanged. The configuration should match the following picture.