Quick start manual

STER PMU Quick Start Manual Getting started
13
Figure 3.4: HyperTerminal serial connection settings dialog
6. Open the connection.
7. Direct the input to the console, and press the ENTER key to check if the device is communicating. Device
should respond with a ProSeries login prompt.
8. Enter username and password to log into the device. The factory default user settings are as follows:
Login
root
Password
root
Figure 3.5: HyperTerminal serial connection settings dialog
9. Type editconf and press Enter. PS110 will enter the text-driven menu interface for setting device
configuration:
Figure 3.6: Device configuration setup main menu
To select a menu item, type the preceding menu number and press the ENTER key. Use the ESC key to exit and
return to the previous menu. All the parameters can be stored into the non-volatile memory space of the device,
but only if the save command is issued.
10. Setting network configuration.
PS110 serial to Ethernet converter requires a valid IP address to operate within the user's network environment. If
the IP address is not readily available, contact the system administrator to obtain a valid IP address for the device.