User's Manual

- 15 -
EUI address if it isn’t designated before.
Response
OK<CR>
4.4.15. AT+PERMIT
Description
Permit other nodes to join the network. (0~254s, 255=continuance)
Response
OK<CR>
4.4.16. AT+JOIN
Description
Join a network using the specified network parameters.
Response
OK<CR>
4.4.17. AT+LEAVE
Description
Leave the current network.
Response
OK<CR>
4.4.18. AT+SLEEP
Description
Sleep mode only for end-device. (0: none-sleep, 1: sleep and wake up periodically and
possible to transmit data, 2: similar to mode 1 but can deep-sleep if there’s no data
transmission quite a while, 3: deep-sleep)
Response
Information of this node
…
OK<CR>
4.4.19. AT+NODETYPE
Description
Get/Set the node type. (0: none, 1: coordinator, 2: router, 3: end-device) It’s applied
after resetting the node.
Example
AT+NODETYPE=1<CR>
OK<CR>
AT+NODETYPE?<CR>
1<CR>
OK<CR>
4.4.20. AT+LISTEN
Description
Get/Set the listen mode to receive a message or GPIO value from the network. It is
presented by a form of “+(or ++ when GPIO)EUI address of sender|message”.
Example
AT+LISTEN=1<CR>
OK<CR>
AT+LISTEN?<CR>
1<CR>
OK<CR>
4.4.21. AT+OPMODE
Description
Get/Set the operation mode. (0: none, 1: pairing, 2: unicast, 3: multicast, 4: