User's Manual

- 12 -
Response
4.3.7. ATS<0 or 40>
Description
Get/Set the S-registers.
(S0: number of rings before auto-answer (under 10),
S40: determine thruput (This is the same with the value of data transport mode))
Example
ATS0=3<CR>
OK<CR>
ATS40?<CR>
1<CR>
OK<CR>
4.3.8. ATZ
Description
Reset the node. (initialize current network status)
Response
OK<CR>
4.3.9. AT&F
Description
Factory reset. (initialize cookies)
Response
OK<CR>
4.3.10. +++
Description
Interrupt data mode.
Response
OK<CR>
4.4. Extended AT Commands
4.4.1. AT+EUI?
Description
Get the 64-bit EUI address. (IEEE address, long address)
Response
000D6F0000488434<CR>
OK<CR>
4.4.2. AT+DESTEUI
Description
Get/Set the 64-bit destination EUI address for data transmission. (pairing, point-to-
point and send GPIO values)
Example
AT+DESTEUI=000D6F000048842F<CR>
OK<CR>
AT+DESTEUI?<CR>
000D6F000048842F<CR>
OK<CR>
4.4.3. AT+NODEID?
Description
Get the 16-bit node ID. (network address, short address) The only coordinator has a
fixed value (0x0000) and other device types are assigned at random.