User Manual Copyright ⓒ 2019. Lab-T, Inc.
B2M Manual Power On/Off Button for 1 sec Bluetooth Intercom Pairing 1. Turn on the B2M(Factory default) or Button for 8 sec 2. When B2M and headset are in pairing mode, they are connected automatically.
1. When you start the Bluetooth intercom, the mesh intercom starts automatically. 2. When the Bluetooth intercom is stopped, the mesh intercom is automatically stopped. Creating the Mesh 1. [Creator] Press and Hold the button for 5 seconds to create a mesh. 2. [Participant] If you receive a mesh invitation message, tap the button to join the mesh. If you receive a mesh invitation message, tap the button 2 times to reject the mesh. Searching the Mesh 1.
FCC, IC Warning statement Certification and Safety Approvals FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules.
The antenna used in this transmitter must be installed such that a minimum separation distance of 59.00 mm is always maintained from the human head. We, Sena Technologies, Inc. confirm that when equipped in authorized helmet models, the distance between antenna and one’s head will not be less than 59.00 mm. FCC Caution Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment.
Industry Canada Statement This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two condition: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation. IC Declaration of Conformity (Industry Canada) This device complies with Industry Canada RSS applicable to unlicensed radio equipment.
utilise et peut émettre de l'énergie de fréquence radio. S'il n'est pas installé et utilisé conformément aux instructions, il peut causer des interférences nuisibles aux communications radio. Cependant, rien ne garantit que des interférences ne se produiront pas dans une installation particulière.
L'antenne utilisée dans cet émetteur doit être installée de manière à respecter une distance minimale de 59,00 mm par rapport à la tête humaine. Nous, Sena Technologies, Inc., confirmons qu’avec les modèles de casques autorisés, la distance entre l’antenne et la tête ne sera pas inférieure à 59.00 mm.
