Wireless Interface Module W.I.
Wireless Interface Module 1.0 WIM Introduction 1.1 Background The Wireless Interface Module (WIM) is a Bluetooth enabled electronic control unit designed for use with Harley Davidson touring motorcycles. replaces the wired headset. The WIM will interface with both Premium and Standard infotainment units and The WIM is not compatible with Harley’s Cruiser, Sportster, or Street lines. The WIM will be sold in any market touring motorcycles are sold. Figure 1: WIM System Block Diagram 1.
Wireless Interface Module 1.3 DUT Orientation Orientation A Orientation B Orientation C Table 1: DUT Orientations 1.
Wireless Interface Module Pin Signal 16 Rear Headset Left 15 Rear Headset Right 14 Headset Common GND 13 Front Headset Left 12 Front Headset Right 11 USB GND 10 Rear Microphone 9 Front Microphone 8 Microphone Common GND 7 USB Power (5V) 6 CAN Plus 5 CAN Minus 4 USB Data Plus 3 USB Data Minus 2 POWER GND 1 POWER Input Table 2: WIM Connector Pin Table
Wireless Interface Module This equipment should be installed and operated with minimum 20 cm between the radiator and your body. FCC Part 15 Subpart C Section 15.247 FCC ID: S7A-SP40 FCC Compliance Statement FCC Part 15.19 Statements: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
