User's Manual

| 10U
9
3.2 10U for Schuberth
1. Before you install the 10U, remove the cheek pads and ear pads of your helmet.
2. Align the right speaker with the right cheek pad base and insert the two clasps in the corresponding notches.
3. Unfasten the two snaps of the center pad in the back and insert the battery unit between the external shell and the
inner shell. Click the two snaps through the snap holder of the battery unit.
4. Slide in the antenna between the external shell and the left inner shell. Align its snap holder with the bottom left snap.
5. Align the left speaker with the left cheek pad base and insert the two clasps in the corresponding notches.
6. Insert the control buttons unit between the external shell and the left inner shell. Align its snap holder with the front left
snap.
7. Hide the wires behind the center pad and reinstall the cheek pads. Make sure to click the snaps through the snap
holders
3.2 Handlebar Remote
1. Gently spread the two ends of the Handlebar Remote.
2. Clip it on the left handlebar of your motorcycle. Make sure you can comfortably control the Joystick with your left thumb.