User's Manual
| 10U
11
4.2 Powering On and Off
4.2.1 Headset
To power on the headset, press the (+) Button and the (-) Button at the same time while hearing ascending beeps and a
voice promptHello-) Button at the same time while hearing
Goodbye
4.2.2 Handlebar Remote
To power on the device, tap the Front Button and the blue LED will appear. To power off the device, press and hold the
Front Button and the Rear Button for two seconds until red LED flashes.
4.3 Pairing the Headset and the Handlebar Remote
Turn on the headset and the Handlebar Remote. On the headset, press and hold the (+) Button for 10 seconds until you
Configuration menuRemote control
pairingblue.
The main unit and the Handlebar Remote will be paired shortly after.
4.4 Charging
You can charge the headset and the Handlebar Remote by connecting the supplied USB power & data cable into a
standard micro-USB cable to charge the units. The charging
LEDs turn red while they are charging and turn blue when they are fully charged. It takes about 2.5 hours to be
completely charged.
4.5 Checking the Battery Level
When the headset or the Handlebar Remote is powering on, the red LED flashes rapidly indicating the battery level.
4 flashes = High, 70~100%
3 flashes = Medium, 30~70%
2 flashes = Low, 0~30%
4.6 Volume Adjustment
You can easily adjust the volume by moving the Joystick up or down. You will hear a beep when the volume reaches the
maximum or minimum level. The volume is set and maintained independently at different levels for each audio source
even when you reboot the headset. For example, once you set the volume for mobile phone handsfree, it will not change
even if you adjust the volume for your Bluetooth MP3 music. However, if you adjust the volume during stand-by mode, it
will affect volume levels of every audio source.
4.7 Sena Softwares
4.7.1 Sena Device Manager