User's Manual

However, if you start intercom by voice and end it manually by tapping the Jog Dial, you will not be able to start intercom
by voice temporarily. In this case, you have to tap the Jog Dial to restart the intercom. This is to prevent repeated
unintentional intercom connections by strong wind noise. After rebooting the 10C, you can start intercom by voice again.
14.1.4 Enabling/Disabling Voice Prompts
Voice Prompt
“Voice prompt”
Factory Default
Enable
Enable
Tap the Phone Button
Disable
Tap the Jog Dial
You can disable voice prompts by configuration setting, but the following voice prompts are always on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
- Voice prompts for speed dial
- Voice prompts for FM radio functions
14.1.5 Delete All Bluetooth Pairing Information
Voice Prompt
“Delete all pairings”
Factory Default
N/A
Execute
Tap the Phone Button
To delete all Bluetooth pairing information of the 10C, rotate the Jog Dial until you hear a voice prompt, “Delete all
pairings”, and tap the Phone Button to confirm.
14.1.6 Exit Voice Configuration Menu
Voice Prompt
“Exit configuration”
Factory Default
N/A
Execute
Tap the Phone Button
To exit voice configuration menu and get back to stand-by mode, rotate the Jog Dial until you hear a voice prompt, “Exit
configuration”, and tap the Phone Button to confirm.