User's Manual

6 PAIRING THE 10C WITH BLUETOOTH DEVICES
Before using the 10C Bluetooth headset with any other Bluetooth devices for the first time, you will need to pair them
together. You can pair the 10C with Bluetooth mobile phones, Bluetooth stereo devices such as MP3 players, or
motorcycle specific Bluetooth GPS navigation, and with other Sena Bluetooth headsets. The pairing operation is required
only once for each Bluetooth device. The headset remains paired with the devices and automatically reconnects to them
when they are within range. You will hear a high toned single beep and a voice prompt whenever the headset reconnects
to the paired device: “Phone connected” to a mobile phone, “Media connected” to a Bluetooth stereo device.
6.1 Mobile Phone Pairing - Mobile Phone, Bluetooth Stereo Device
Follow the procedure below to pair a mobile phone, or a Bluetooth stereo device such as an MP3 player with your 10C.
1. Turn on the 10C and press and hold the Phone Button for 5 seconds until the LED flashes red and blue alternately and
you hear multiple beeps. You will hear a voice prompt, “Phone pairing”.
2. Search for Bluetooth devices on your mobile phone. Select the Sena 10C in the list of the devices detected on the
mobile phone.
3. Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
4. The mobile phone confirms that pairing has been completed and the 10C is ready to use. You will hear a voice prompt,
“Your headset is paired”.
5. If the pairing process is not completed within three minutes, the 10C will return to stand-by mode.
Note:
- If the Bluetooth connection between the headset and a mobile phone is disconnected, tap the Phone Button to recover
the Bluetooth connection immediately.
- If the Bluetooth connection between the headset and a media player is disconnected, press the Jog Dial for 1 second to
recover the Bluetooth connection and play.
6.2 Second Mobile Phone Pairing - Second Mobile Phone, GPS, and SR10
Typical Bluetooth headsets can connect with only one HFP (Hands-Free-Profile) Bluetooth device such as mobile phone,
GPS, and Sena SR10, but second mobile phone pairing pairing allows the headset to connect with two HFP devices
simultaneously. So, when you already have a mobile phone connected with the 10C, you can also pair and connect a
second mobile phone or other HFP devices.
1. To pair the HFP device, press and hold the Jog Dial for 5 seconds until the red LED flashes red rapidly and you hear a
voice prompt, “Intercom pairing”.
2. Within 2 seconds, tap the Phone Button again, then the LED flashes blue rapidly and you will hear a voice prompt,
“Second mobile phone pairing”.
3. Search for Bluetooth devices on the HFP device. Select the Sena 10C in the list of the devices detected on the HFP
device.
4. Enter 0000 for the PIN. Some HFP devices may not ask for the PIN.