User's Manual

20S
56
Type Function
Button Command
Voice
Command
LED Beep
Button Duration
FM radio
Seek stations Jog Dial
Rotating
while
pressing
- -
High tone
triple beeps
Scan up FM
band
Phone Button
Double
tapping
- - -
Stop
scanning
Phone Button
Double
tapping
- -
High tone
double beeps
Save preset
while
scanning
Phone Button Tapping - -
High tone
double beeps
Reset
Factory reset
Phone Button 12 sec - Solid red
High tone
double beeps
Jog Dial within 5 sec
Fault reset Reset Button Pressing - - -
CERTIFICATION AND SAFETY APPROVALS
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antennae
•
Increase the separation between the equipment and the receiver
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.