User's Manual

5
GETTING STARTED
Attaching the Sena Bluetooth pack to GoPro
1. Slide hooked end of the Bluetooth pack into the
groove on the right side of the camera body.
2. Push the Bluetooth pack into the HERO Bus port
on the back of the camera.
3. Connect USB connector between GoPro and Sena
Bluetooth pack.
6
Removing the Bluetooth pack from GoPro HERO
1. Disconnect USB connector
2. Pull back on left side of theBluetooth pack marked
with thearrow to disconnect from the HERO bus
port.
3. Slide hooked end of theBluetooth pack out of
cameragroove.
7
Powering On/Off
1. Push the Power Switch down to power on. Then the
LED flashes blue.
2. Push the Power Switchupward to power off.The LED
flashes blue and you will hear the voice prompt
“Goodbye”.
Factory Reset
When the Bluetooth pack is not working properly
or is in faulty status for any reason, you can reset
the Bluetooth pack.
1. Press and hold the Pairing Button for 10 seconds
to enter the factory reset mode. Then the LED turns
on red.
2. Tap the Pairing Button to reset the Bluetooth pack.
8
OPERATION
Pairing with SENA headsets
1. Pressand hold the Pairing Buttonfor 5 seconds.
2. When hearing high-tone beeps, release thePairing
Button. Then the LED flashes red and blue
alternately.
3. Search for and select the Bluetooth pack on the
SENA headset to pair with it. For details on pairing,
refer to the User Guide of the SENA headset.
4. When the LEDflashes blue twice, the paring is
completed and the Bluetooth pack is ready to use.