User's Manual

| SMH10R
9
6. SMH10R CONFIGURATION SETTING
You can set the configuration of the SMH10R by the voice menu instruction as below.
1 To enter into voice configuration menu, press and hold the Center Button for 10 seconds until the LED shows solid
blue and you hear high tone double beeps. You will also hear a voice prompt saying “Configuration menu”.
2 Press the (+) Button or (-) Button to navigate between the menus. You will hear voice prompts for each menu items
as below.
3 You can enable the feature or execute the command by press the Center Button, or disable the feature by press the
Center Button again. If any button is not pressed within 10 seconds, the SMH10R will exit the configuration and goes
back to stand-by.
4 If you want to exit the configuration immediately, press the (+) Button or (-) Button and hold it until you hear a voice
prompt, “Exit configuration”, and press the Center Button.
The voice prompt for each menu item is as below:
(1) Phone pairing
(2) Multipoint pairing
(3) Phone selective pairing
(4) Media Selective pairing
(5) VOX phone
(6) VOX intercom
(7) VOX sensitivity
(8) Voice prompt
(9) Delete all pairings
(10) Factory reset
(11) Exit configuration
6.1 Mobile Phone Pairing
Voice Prompt
“Phone pairing”
Factory Default
N/A
Enable / Disable
Press the Center Button
Press the (+) Button or the (-) Button until you hear a voice prompt, “Phone pairing” to select a phone pairing menu. If
this menu is selected, the SMH10R will enter phone pairing mode for your mobile phone. Please refer to the section 7.1
for details on mobile phone pairing. If you press the (+) or (-) Button for menu navigation, it will stop the pairing operation.
6.2 Multipoint Pairing
Voice Prompt
“Multipoint pairing”
Factory Default
N/A
Enable / Disable
Press the Center Button