User's Manual

| SMH10R
7
 Speakers
 Attachable Boom Microphone
 Wired Microphone
 Battery Pack
 Speaker Pad
 Attachable Boom Microphone Holder
 Velcro Pad for Boom Microphone
 Velcro Pad for Speaker
 Velcro Pad for Boom Microphone Holder
 Velcro Pad for Wired Microphone
 Velcro Pads for Battery Pack
 Mounting Cradle
 Microphone Sponge
 USB Power & Data Cable
3. INSTALLING THE SMH10R ON YOUR HELMET
To securely install the SMH10R on the helmet, please follow the procedure.
1 Locate a proper surface on the helmet to attach the Mounting Cradle, clean the helmet surface location with a
moistened towel, and allow to drying thoroughly.
2 Adhere with double sided tape on the back side of the Mounting Cradle to the surface on the helmet.
3 Clamp the SMH10R main unit to the Mounting Cradle.
4 Place the helmet speakers along with the Velcro pads, centered to your ear, in the ear pockets of the helmet. If the
helmet has deep ear pockets, you can you the speaker pads to place the speakers closer to your ears. Connect it to
the 4 pin speaker connector of the SMH10R main unit.
5 There are 2 different type of microphone can be installed to your helmet. In case of the Attachable Boom Microphone,
place the Velcro end of the boom microphone between the internal helmet cheek pad and the internal wall of the
helmet shell. The Attachable boom microphone should be mounted so it is facing close to your mouth when you wear
the helmet. In the case of the Wired Microphone, attach the enclosed Velcro pad for wired microphone to the inside
of the chin guard for full-face helmets. Place the wired microphone on the Velcro pad and connect it to the 2 pin
connector of the SMH10R main unit.
6 Place the battery on the helmet and we recommend rear side of the helmet with Velcro, connect it to the 2 pin battery
connector of the SMH10R main unit.