User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. PACKAGE CONTENTS
- 3. INSTALLING THE SMH10R ON YOUR HELMET
- 4. POWERING ON/OFF AND CHARGING
- 5. Volume Adjustment
- 6. SMH10R CONFIGURATION SETTING
- 6.1 Mobile Phone Pairing
- 6.2 Multipoint Pairing
- 6.3 Phone Selective Pairing
- 6.4 Media Selective Pairing
- 6.5 Enabling/Disabling Voice Activated Phone Answering
- 6.6 Enabling/Disabling Voice Activated Intercom
- 6.7 Setting VOX Sensitivity
- 6.8 Enabling/Disabling Voice Prompts
- 6.9 Delete All Bluetooth Pairing Information
- 6.10 Reset to Factory Default Setting
- 6.11 Exit Voice Configuration Menu
- 7. PAIRING THE SMH10 WITH BLUETOOTH DEVICES
- 8. PAIRING WITH SELECTIVE PROFILE: A2DP STEREO OR HANDSFREE
- 9. Intercom Pairing
- 10. FUNCTION PRIORITY
- 11. STEREO MUSIC
- 12. MOBILE PHONE CALL MAKING AND ANSWERING
- 13. TWO-WAY INTERCOM
- 14. THREE-WAY CONFERENCE INTERCOM
- 15. FOUR-WAY CONFERENCE INTERCOM
- 16. THREE-WAY CONFERENCE PHONE CALL WITH INTERCOM PARTICIPANT
- 17. INTERCOM FAILURE
- 18. INTERCOM RECONNECTION
- 19. FAULT RESET
- 20. FIRMWARE UPGRADE
| SMH10R
6
2. PACKAGE CONTENTS
Headset Main Unit
(+) Button / (-) Button
Volume adjustment
Navigate through configuration menu
Track-forward and track-back
Center Button
Answer and end a mobile phone call
Reject an incoming mobile phone call
Start and end intercom conversation
Play and pause Bluetooth stereo device
Enter into intercom pairing mode
Enter into voice configuration setting
DC Power Charging & Firmware Upgrade Port
Speaker Connector (4 pin female type)
Battery Pack Connector (2 pin male type)
Microphone Connector (2 pin female type)