User's Manual

| SMH10R
14
7.2 Bluetooth Stereo Device Pairing
If the Bluetooth stereo device is integrated with the mobile phone such as smartphones, you don’t need to pair the
SMH10R with it separately. When the SMH10R is paired with the mobile phone, it is also paired as a stereo music device.
If you have a stand-alone Bluetooth stereo device, follow the pairing procedure separately. The procedure is the same as
the procedure of “6.1 Mobile Phone Pairing”.
Note:
1 If Bluetooth connection between the headset and a mobile phone is disconnected, press the Center Button for 3
seconds to recover the Bluetooth connection immediately.
2 If Bluetooth connection between the headset and a media player is disconnected, press the Center Button for 1
second to recover the Bluetooth connection and play.
7.3 Bluetooth GPS Navigation Pairing
You can listen to voice instruction from Bluetooth GPS navigation. Some GPS systems use mobile phone profile (HFP,
Hands-Free Profile) and others use stereo music profile (A2DP, Advanced Audio Distribution Profile). Most motorcycle
specific GPS systems use mobile phone profile for turn-by-turn voice instruction. You can simultaneously use a mobile
phone and a GPS which uses mobile phone profile by one of the following procedures.
7.3.1 Multipoint GPS Pairing
If you use GPS only for turn-by-turn voice instructions, not for Bluetooth stereo music streaming, multipoint pairing is
recommended for the GPS connection. Multipoint Bluetooth pairing allows the SMH10R to connect two HFP devices at
the same time: mobile phone and GPS navigation. Follow the steps below to pair the GPS using the multipoint pairing.
1 To enter into voice configuration menu, press and hold the Center Button for 10 seconds until you will hear a voice
prompt saying “Configuration menu”.
2 Press the (+) Button once and you will hear a voice prompt saying “Mobile phone pairing”.
3 Search for Bluetooth devices on the GPS navigation screen. Select the Sena SMH10R in the list of the devices
detected on the GPS.
4 Enter 0000 for the PIN.
5 The GPS confirms that pairing has completed and the SMH5 is ready to use. You will hear a voice prompt from the
SMH10R saying “Your headset is paired”.
6 If the pairing process is not completed within three minutes, the SMH10R will return to stand-by mode.
The pairing diagram for multipoint GPS pairing is shown in the figure below.
7.3.2 GPS Pairing as Mobile Phone
If GPS is not only used for turn-by-turn voice instructions but also is your preferred Bluetooth stereo music source, you
can pair the GPS to the SMH5 by following the simple procedures in “6.1 Mobile Phone Pairing”. When you do this, the
SMH10R thinks the GPS is a mobile phone. But the SMH10R can directly pair an additional mobile phone.
Note:
You have to use a motorcycle specific GPS which transmits turn-by-turn voice instruction to the headset by Bluetooth.
Most automotive GPS systems don’t have this feature.