User's Manual
Table Of Contents
- 1. INTRODUCTION
- 2. PACKAGE CONTENTS
- 3. INSTALLING THE SMH10R ON YOUR HELMET
- 4. POWERING ON/OFF AND CHARGING
- 5. Volume Adjustment
- 6. SMH10R CONFIGURATION SETTING
- 6.1 Mobile Phone Pairing
- 6.2 Multipoint Pairing
- 6.3 Phone Selective Pairing
- 6.4 Media Selective Pairing
- 6.5 Enabling/Disabling Voice Activated Phone Answering
- 6.6 Enabling/Disabling Voice Activated Intercom
- 6.7 Setting VOX Sensitivity
- 6.8 Enabling/Disabling Voice Prompts
- 6.9 Delete All Bluetooth Pairing Information
- 6.10 Reset to Factory Default Setting
- 6.11 Exit Voice Configuration Menu
- 7. PAIRING THE SMH10 WITH BLUETOOTH DEVICES
- 8. PAIRING WITH SELECTIVE PROFILE: A2DP STEREO OR HANDSFREE
- 9. Intercom Pairing
- 10. FUNCTION PRIORITY
- 11. STEREO MUSIC
- 12. MOBILE PHONE CALL MAKING AND ANSWERING
- 13. TWO-WAY INTERCOM
- 14. THREE-WAY CONFERENCE INTERCOM
- 15. FOUR-WAY CONFERENCE INTERCOM
- 16. THREE-WAY CONFERENCE PHONE CALL WITH INTERCOM PARTICIPANT
- 17. INTERCOM FAILURE
- 18. INTERCOM RECONNECTION
- 19. FAULT RESET
- 20. FIRMWARE UPGRADE
| SMH10R
11
6.6 Enabling/Disabling Voice Activated Intercom
Voice Prompt
“VOX intercom”
Factory Default
Disable
Enable / Disable
Press the Center Button
Press the (+) Button or the (-) Button until you hear a voice prompt, “VOX intercom”. If this feature is enabled, you can
initiate an intercom conversation with the last connected intercom friend by speaking any word loudly enough. The most
effortless way to trigger intercom VOX is to blow into the microphone as if blowing dust off the microphone. If you start an
intercom conversation by VOX, the intercom terminates automatically when you and your intercom friend remain silent for
20 seconds. However, if you manually start an intercom conversation by press the Center Button, you have to terminate
the intercom conversation manually.
However, even when this feature is enabled, if you terminate intercom conversation manually with the Center Button, you
are not a ble t o s tart i ntercom b y voice t emporarily. I n t his c ase, you have t o pr ess t he Center B utton to r estart t he
intercom. T his is to prevent repeated u nintentional intercom c onnections by strong wind noise. If you press the Center
Button t o s tart an i ntercom c onversation, i t i s no t t erminated b y 2 0 s econds of s ilence. After t urning SMH10R off and
on, you can start intercom by voice again.
6.7 Setting VOX Sensitivity
Voice Prompt
“VOX sensitivity (value)”
Factory Default
3
Value Adjustment
Press (+) or (-) Button
Value Save
Press the Center Button
Press the (+) Button or the (-) Button until you hear a voice prompt, “VOX sensitivity (value)”. If you enter the mode, you
will hear a prompt saying the current VOX sensitivity value. To press the Center Button will lead you to value adjustment
mode. You may adjust the VOX sensitivity value by pressing (+) or (-) Button. The value of 5 is the highest sensitivity set-
up and 1, the lowest one. After you completed the setting, press Center Button to apply the changes.
6.8 Enabling/Disabling Voice Prompts
Voice Prompt
“Voice prompt”
Factory Default
Enable
Enable / Disable
Press the Center Button